Key points for selecting stainless steel cable tray

Oct 09, 2025 Leave a message

I‌. Core Material Characteristics: Select the Right Stainless Steel Grade Based on Your Needs

Stainless steel corrosion resistance requirements vary significantly across different applications, so prioritize the appropriate grade:

 

1.Chemical/Severe Corrosion Applications: Choose molybdenum-containing 316L stainless steel with a chromium content of ≥16%, nickel ≥10%, and molybdenum ≥2%. This grade resists highly corrosive media like hydrochloric acid and sulfuric acid, preventing pitting and intergranular corrosion. Avoid 304 stainless steel, as it lacks molybdenum and typically has a lifespan of less than one year in highly corrosive environments.

 

2.Coastal/High Salt Fog Applications: Prefer 316 stainless steel (molybdenum content 1.8%-2.5%) or 304L stainless steel (low carbon, carbon content ≤0.03%). 316 resists marine salt spray, while 304L reduces the risk of intergranular corrosion after welding. Avoid ordinary 304 stainless steel, as it is prone to surface rust after long-term exposure to salt spray.

 

3.For ordinary indoor/dry environments: 304 stainless steel is sufficient. Its chromium-nickel alloy meets the corrosion resistance requirements of everyday air and dusty environments, offers a higher cost-effectiveness than the 316 series, and offers excellent processability, making it suitable for complex shapes (such as elbows and tees).

II. Key Technical Parameters: Ensure Structural Safety and Compatibility

 

1.Corrosion Resistance Parameters:

Surface Roughness: Required to be ≤ Ra1.6μm (polished) to reduce dust and moisture adhesion and minimize the likelihood of localized corrosion.
Passivation Film Thickness: After passivation treatment, the surface passivation film (Cr₂O₃) must be ≥8μm thick. This can be tested with an eddy current thickness gauge. A film that is too thin can accelerate oxidation.

 

2.Mechanical Performance Parameters:

Yield Strength: ≥205MPa (304/316 material) to ensure the bridge does not deform when carrying cables (e.g., 5-8 6mm² cables per meter);
Tensile Strength: ≥520MPa to prevent structural fracture due to lifting and stretching during installation;
Plate Thickness: Select based on span length: 1.0mm for spans under 1.5 meters, 1.2mm for spans 2-3 meters, and 1.5mm for spans over 3 meters to prevent sagging under long-term loads.

 

3.Suitability Parameters:

Trough Width/Height: Must be 15%-20% larger than the total diameter of the cables being laid. For example, for a cable bundle with a total diameter of 80mm, select a bridge 100mm wide by 50mm high to allow for heat dissipation.
Connection Method: For chemical applications, bolt connections (with corrosion-resistant gaskets) are recommended over welding (which can create corrosion weaknesses). For general applications, snap-on connections are available for improved installation efficiency.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry