The installation requirements for single-pipe rigid hangers mainly include the following points:
The hanger should have a vertical adjustment facility. During installation, the adjustment facility should be used to adjust the pipeline to the predetermined elevation and use a gauge or force wrench to confirm that the hanger is in a loaded state. After the elevation adjustment of the pipeline is completed, it should be locked to prevent the hanger rod from rotating and loosening.
The hanger should be installed so that the hanger can swing freely with the horizontal displacement of the pipeline. Only small-diameter, light-loaded and vibration-free pipe hanger hangers are allowed to be directly fixed in concrete components.
When the hanger is directly suspended on the steel beam with a steel beam, the clamp fastening device should be tightened to ensure that the clamp is fixed to the steel beam. For C-beam clamps of types 83 and 84, the screw tightening torque should comply with the provisions of the design documents.
When directly welding or screwing with the building steel structure, it should comply with the requirements of GBJ17GBJ 205. It is strictly forbidden to open holes in the steel structure with gas cutting. Drilling holes in building steel structures must be approved in advance by the relevant designers.
To avoid the high temperature of welding affecting the concrete strength, the welding time should be shortened when welding with concrete parts. Intermittent welding can be used when necessary.
Welding with alloy steel pipes should be carried out in the factory. If it is necessary to weld on site, the preheating before welding and the heat treatment after welding should be strictly implemented.
The bearing surfaces of each load-bearing plate welded on the pipeline should be in the same plane perpendicular to the axis of the pipeline. The pipe clamp must be installed close to all load-bearing ribs to ensure that the load-bearing ribs are evenly loaded.
These requirements apply to the installation of rigid hangers, ensuring the stability and safety of the pipeline system.




