Belt support acceptance criteria

Jan 03, 2025 Leave a message

1, Before acceptance

The belt bracket needs to undergo strict quality inspection before leaving the factory, mainly including the following aspects:

1. Whether the size and model of the equipment meet the design requirements;

2. Whether the material meets relevant standards;

3. Whether the processing quality of each part meets the requirements;

4. Whether the surface treatment of the equipment meets the specified requirements;

5. Whether the installation foundation of the equipment meets the requirements;

6. Whether the accessories of the equipment are complete and can be used normally.

Acceptance can only be carried out after all the above aspects meet the design standard requirements.

2, Acceptance process

1. Belt bracket assembly

During the assembly process, the following points should be noted:

(1) The assembly blank requires firmness and reliability;

(2) Before assembling the pulley, the bearings must be cleaned and oiled;

(3) All nuts should be applied with moderate force and should not be too tight or too loose;

(4) The pulley should be centered, and the vertical distance and levelness should meet the requirements.

2. Check

After assembly, perform the following checks:

(1) Check whether the connecting nuts of each part are tightened;

(2) Check if there is any bearing sticking problem on the pulley;

(3) Check if the contact between the pulley and the bracket is normal;

(4) Check the correct fit between the pulley drive and the transmission device;

(5) Check for foreign objects and debris inside the bracket.

3, Acceptance criteria

The acceptance of the belt bracket mainly checks the following aspects:

1. Appearance inspection

Are there any cracks, burrs, or other damages.

2. Dimensional inspection

The symbol design requires a deviation of within 2mm.

3. Material inspection

The material should comply with relevant standards, and of course, attention should be paid to corresponding indicators such as strength and toughness.

4. Quality inspection of processing in various parts

All aspects should meet the design requirements.

5. Assembly quality inspection

The assembly requirements must be firm and reliable, and all nuts must be applied with moderate force, not too tight or too loose.

【 Summary 】

The acceptance criteria for belt supports are the key guarantee for the normal operation of equipment, and the acceptance needs to be strictly carried out in accordance with relevant regulations to avoid potential hazards in use caused by unqualified problems. This article introduces the key content and standards of belt support acceptance, and I believe it will be helpful for understanding the inspection specifications of new equipment.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry